C:\DOCUME~1\LESSIL~1\Desktop\ORIGIN~1\top.asp

Mic/ Instrument SEARCH

Select your instrument above for the best possible microphone solution.

AMT

applied microphone technology, inc.

AMT

C:\WINDOWS\Desktop\Newly Created Pages\menu.asp

Clip Assembly & Instructions For

Violin, Viola, & Mandolin

See: http://www.appliedmicrophone.com for more info!

1. Loosen Hex Set Screw with wrench. (Do not remove) Pull out small pin.

2. Rotate suede piece 180 degrees.

3. Replace with long pin for violin on opposite side. (Side with suede)

Then, tighten the hex screw back tight with hex wrench.

4. Remove rubber from clamp (see figure D). Take half round piece, remove brown paper. (see figure E)

Press piece with tape to clamp where the rubber was removed.

5. Replace B1 short screw with C2 long screw and clamp is ready for Violin.

* Warning: Over tightening may damage violin.

Top of Clamp.jpg (115919 bytes)

Bottom of Clamp.jpg (70303 bytes)

Screw B1.jpg (39819 bytes) Screw C2.jpg (54980 bytes)

B1= Short Screw for Clarinet & Flutes.

C2=Long Screw

for Violin.

C:\WINDOWS\Desktop\Newly Created Pages\menu.asp

AMT